GSP | Bit | P50534B

• Gerber Gold routing bits are designed for greater performance and longer tool life.
• Made from the highest quality micrograin carbide to the tightest tolerances in the industry
• Coated with titanium nitride to enhance durability even further
• The result is superior edge quality and lower tooling cost
• These high performance bits can be used with all Gerber routers/engravers, as well as with other automated and manual routers
• Unlike the spiral flute bits, these bits have a single straight cutting edge
• Doesn’t pull up on the work piece
• Straight flute allows the bit to “shear” the chip off at the top edge of the material being cut without leaving a burr. The chip extraction, however, will not be as good as with a spiral bit

Single-Flute Radial Bits

• Ideal for cutting sheet aluminum and brass with a thickness of .060” (1.5mm) and less, soft woods, soft alloy aluminum. Unlike the spiral flute bits, these bits have a single straight cutting edge which doesn’t pull up on the work piece. This straight flute allows the bit to “shear” the chip off at the top edge of the material being cut without leaving a burr. The chip extraction, however, will not be as good as with a spiral bit.